Materials For Nacelle And Hub Transport Covers
Review materials for wind turbine nacelle covers and hub protection during transport. Specify openings, contact surfaces and fastenings for a material trial.
Material references for sampling
Compare these catalog constructions with your finished-product requirements.
These cover-fabric references are starting points for sampling. Confirm the material, inner contact layer, fastenings and finished-cover performance for your equipment.
- Weight
- 650gsm
- Width
- 1.05-3.2m
- Technology
- Knife Coated
- Base fabric
- 1000*1000D 20*20
- Surface
- Glossy/Matte
- Roll length
- 50m/100m
- Weight
- 850gsm
- Thickness
- 0.68mm
- Width
- 1.05-3.2m
- Technology
- Knife Coated
- Base fabric
- 1000*1000D 23*23
- Surface
- Glossy/Matte
- Roll length
- 50m/100m
Wind Turbine Nacelle & Hub Protection in use
Roll-material references for temporary transport and storage covers over nacelle openings, hubs and exposed equipment interfaces.
Wind Turbine Nacelle & Hub Protection Materials
Temporary covers protect open interfaces while nacelle assemblies and hubs move through a factory, storage yard or transport route. Define the opening or equipment area to be enclosed, the access needed during handling and the surfaces available for attachment.
This application concerns fabricated soft covers used during logistics. The permanent nacelle housing is a different component. A clear drawing helps keep the material discussion focused on the temporary cover you intend to make.
Material Selection
Panel size, support spacing and the frequency of removal guide the choice of a reinforced coated fabric. Discuss the coating finish and flexibility together with the way the cover will fold and be packed between uses.
Electrical connectors, painted surfaces and sharp interfaces may call for separate contact protection within the cover assembly. Describe those details before sampling; the outer fabric does not resolve every contact or restraint requirement.
Panels, Seams And Fastenings
Place access flaps and seams where workers can reach them safely. Show how straps, fasteners and reinforced borders transfer load into the cover. Trial the completed edge and opening detail, including water paths at overlaps, rather than testing an unjoined swatch alone.
Include In Your Brief
- Nacelle opening or hub dimensions and transport-frame drawings
- Required access points, removable panels and attachment locations
- Outdoor exposure, storage duration and packing method
- Contact-surface limits, reinforcement and joining process
Questions About Wind Turbine Nacelle & Hub Protection
Is this material for the permanent nacelle shell?
The material discussion here is for temporary fabricated transport and storage covers. It is not a specification for the permanent structural housing.
Can a hub and a nacelle opening share one material grade?
They may share a candidate grade, but the shape, span and fastening loads must be reviewed separately.
Will a cover made from the fabric be waterproof?
The finished result depends on the selected fabric, seams, openings and fastening arrangement. Evaluate the complete cover against your required water-exposure test.
What can Duletai supply?
We supply the material in rolls, with basic slitting services available. Your fabricator designs and makes the finished cover.
Temporary Covers For Exposed Interfaces
Roll-material references for temporary transport and storage covers over nacelle openings, hubs and exposed equipment interfaces.
We supply roll materials and basic slitting services. Share your drawing, exposure conditions and fabrication method to discuss a material sample for this application.