How to Measure Tarp Mesh Opening Size and Open Area

Measure clear mesh openings and estimate geometric open area for a repeating rectangular pattern.

Highlighted opening between the strands of a mesh grid.

Measure the clear gap between the inside edges of neighboring mesh strands. Record both directions, such as 4 mm across by 3 mm along the roll. Open area is the percentage of a representative mesh area occupied by gaps. Two samples can share an opening size and still have different open areas if their strands have different widths.

Measure the gap and the repeat separately

Lay an unstrained sample on a flat surface. Keep the long direction of the roll marked so you can repeat the measurement on another swatch. For a rectangular pattern, measure the clear gap across and along the roll, then measure the distance between the same points on successive repeats in both directions. A scaled close-up image can help when the edges are difficult to read. Keep the scale in the same plane as the mesh.

Measure several gaps in each direction and note the range you see. If the job has a maximum opening size, ask which dimension or measurement convention governs acceptance. Ask how the supplier measures shapes with curved or irregular edges.

A rectangular opening and its repeat measurements for an open-area estimate.
The 4 × 3 mm opening occupies 60% of the area of a 5 × 4 mm rectangular repeat in this example.

Estimate open area for a rectangular repeat

Divide the clear opening area by the area of one repeat, then multiply by 100. Use the same units throughout. A hypothetical mesh with a 4 × 3 mm clear opening and a 5 × 4 mm repeat has an estimated open area of 60%. The calculation is 12 mm² divided by 20 mm². It assumes a uniform rectangular opening. For irregular or variable openings, ask the supplier how it measures the actual open area over a representative part of the sample.

Field to recordExample
Clear opening, across × along4 × 3 mm
Pattern repeat, across × along5 × 4 mm
Geometric open area60% in this example
Sample conditionLaid flat, with roll direction marked

Use both figures in the quote request

Opening size helps you describe the gaps that material can pass through. Open area describes how much of the fabric surface is open. If you need a measured airflow figure, ask for the test setup and conditions. Evaluate the finished cover for its intended load and attachment layout.

When comparing mesh fabrics for debris covers, send the required opening dimensions, how you intend to assess them and any open-area target. Request a sample of the exact construction being quoted and keep the measured swatch with the order record.